What the Axles Component Pack Adds to Your Build
The Axles Component Pack (25 Assorted Axles) is a straightforward expansion for the Robotics Workshop with Micro:Bit system. If you have already built a basic robot and want to add more moving parts, axles let you extend your chassis or create new linkages. The pack contains 25 axles in different lengths, giving you flexibility without needing to cut or modify parts.
What the Kit Record Confirms
- Robotics Workshop with Micro:Bit: Axles Component Pack (25 Assorted Axles): This Axles Component Pack (25 Assorted Axles) is compatible with the Robotics Workshop with Micro:Bit system. Compatibility is guaranteed, so you can use these axles directly with the motors, gears, and structural pieces from your main Robotics Workshop kit without adapters or modifications.

Robotics Workshop with Micro:Bit: Axles Component Pack (25 Assorted Axles) - Robotics Workshop with Micro:Bit: Axles Component Pack (25 Assorted Axles): Ages: 8-18+; Piece Count: 25; Country of Origin: Taiwan; Year Released: 2024 The age range confirms this is suitable for the same builders as the main kit. The 25-piece count means you get a useful variety of axle lengths for one project or several smaller mechanisms.
Planning Your Axle Assembly
Before you start adding axles, look at your current robot design and decide where extra rotational movement would help. Common uses include:
- Building a longer wheelbase for better stability.
- Creating a steering linkage that turns both front wheels together.
- Adding an arm or scoop that rotates up and down.
Because the pack contains assorted lengths, you can test-fit an axle, then swap it for a longer or shorter one without disassembling the whole structure.
A Practical Assembly Sequence
This sequence assumes you already have a basic Robotics Workshop with Micro:Bit robot built. If you are starting from scratch, build the main chassis first, then add axles as needed.
- 1. Identify the axle length you need: Measure the distance between the two points you want to connect. Pick an axle from the pack that is slightly longer than that distance so you have room for retaining clips or spacers.
- 2. Insert the axle through the first mounting hole: Align the axle with the hole in the chassis piece or bracket. Push it through until the end is visible on the other side.
- 3. Add the second component: Slide the wheel, gear, or linkage piece onto the protruding end of the axle. Ensure it fits snugly without forcing it.
- 4. Secure both ends: Use the retaining clips or bushings from your main Robotics Workshop kit to hold the axle in place. The exact method depends on your design, but typically a clip snaps into a groove near each axle end.
- 5. Test rotation: Spin the connected part by hand to check that it rotates freely. If it binds, the axle may be too long or the mounting holes may be misaligned. Swap for a shorter axle or adjust the spacing.
What the Supplied Information Does Not Settle
The catalog confirms compatibility with the Robotics Workshop with Micro:Bit system, but it does not specify exact axle dimensions (lengths in millimeters) or the type of retaining clips included. If your build requires precise measurements, you may need to test-fit several axles. The pack is listed as requiring no batteries, which is expected for a purely structural component set.


